Knowledge & Community You are here

Hello! Yes, for AlSi10Mg aluminum, the minimum wall thickness we recommend is 0.4 mm, with support structures. Without a support structure, then we recommend a thickness of 0.5 mm to maintain the structural integrity of the part. However, this can vary depending on the machine and the specific printing conditions.

[Zimonix]

Hello everyone! Does anyone know what is the minimum wall thickness for printing a 3D part in AlSi10Mg aluminum?

Automatically translated from: Français

See original

0

[Manon Bouriaud]

Hello! Yes, for AlSi10Mg aluminum, the minimum wall thickness we recommend is 0.4 mm, with support structures. Without a support structure, then we recommend a thickness of 0.5 mm to maintain the structural integrity of the part. However, this can vary depending on the machine and the specific printing conditions.

Automatically translated from: Français

See original

0

[Zimonix]

Is 0.4 mm or 0.5 mm sufficient for all applications?

Automatically translated from: Français

See original

0

[Manon Bouriaud]

It’s sufficient to maintain structural integrity under normal conditions. But if your piece is intended for applications where it will be subjected to high mechanical stresses, I would recommend increasing the wall thickness to reinforce the robustness, for example to 1 mm or more, depending on your specific needs.

Automatically translated from: Français

See original

0

[Zimonix]

Thank you very much for these clarifications!

Automatically translated from: Français

See original

0